3.1.1.3 Lab – Install the Power Supply Answers

Last Updated on October 28, 2018 by InfraExam

3.1.1.3 Lab – Install the Power Supply Answers

Lab – Install the Power Supply (Answers Version)

Introduction

In this lab, you will install a power supply in a computer case.

Recommended Equipment

  • Power supply with a compatible form factor to the computer case
  • Computer case
  • Tool kit
  • Power supply screws

Step 1: Open the Computer Case.

  1. Remove the screws from the side panels.
  2. Remove the side panels from the computer case.

Step 2: Install the Power Supply.

  1. Align the screw holes in the power supply with the screw holes in the case.
  2. Secure the power supply to the case with the power supply screws.
  3. If the power supply has a voltage selection switch, set this switch to match the voltage in your area.
    What is the voltage in your area?
    ____________________________________________________________________________________
    Answers may vary. Either 110/115v or 220/230v.
    How many screws secure the power supply in the case?
    ____________________________________________________________________________________
    Answers may vary. Usually 4.
    What is the total wattage of the power supply?
    ____________________________________________________________________________________
    Answers may vary.
  4. This lab is complete. Please ask the Answers to verify your work.
0 0 votes
Article Rating
Subscribe
Notify of
guest
0 Comments
Inline Feedbacks
View all comments