Employees are unable to connect to servers on one of the internal networks. What should be done or checked? Use the "show ip interface brief" command to see if an…
Which statement is correct about how a Layer 2 switch determines how to forward frames? Only frames with a broadcast destination address are forwarded out all active switch ports. Frame…
Refer to the exhibit. Consider that the main power has just been restored. PC3 issues a broadcast IPv4 DHCP request. To which port will SW1 forward this request? to Fa0/1…
Refer to the exhibit. A Layer 3 switch routes for three VLANs and connects to a router for Internet connectivity. Which two configurations would be applied to the switch? (Choose…
Which three statements accurately describe duplex and speed settings on Cisco 2960 switches? (Choose three.) By default, the speed is set to 100 Mb/s and the duplex mode is set…
Refer to the exhibit. Which two conclusions can be drawn from the output? (Choose two.) The port channel ID is 2. The bundle is fully operational. The port channel is…
A network administrator is adding a new WLAN on a Cisco 3500 series WLC. Which tab should the administrator use to create a new VLAN interface to be used for…
A technician is configuring a wireless network for a small business using a SOHO wireless router. Which two authentication methods are used, if the router is configured with WPA2? (Choose…
What action takes place when the source MAC address of a frame entering a switch is not in the MAC address table? The switch replaces the old entry and uses…
Refer to the exhibit. The network administrator configures both switches as displayed. However, host C is unable to ping host D and host E is unable to ping host F.…
A WLAN engineer deploys a WLC and five wireless APs using the CAPWAP protocol with the DTLS feature to secure the control plane of the network devices. While testing the…
To obtain an overview of the spanning tree status of a switched network, a network engineer issues the show spanning-tree command on a switch. Which two items of information will…
Why is DHCP snooping required when using the Dynamic ARP Inspection feature? It uses the MAC address table to verify the default gateway IP address. It redirects ARP requests to…
What protocol should be disabled to help mitigate VLAN attacks? STP CDP DTP ARP Explanation & Hint: To help mitigate VLAN attacks, you should disable DTP (Dynamic Trunking Protocol). DTP…
What action does a DHCPv4 client take if it receives more than one DHCPOFFER from multiple DHCP servers? It sends a DHCPREQUEST that identifies which lease offer the client is…
Refer to the exhibit. What can be concluded about the configuration shown on R1? R1 is configured as a DHCPv4 relay agent. R1 will send a message to a local…
A network administrator is configuring a new Cisco switch for remote management access. Which three items must be configured on the switch for the task? (Choose three.) IP address default…
Refer to the exhibit. A network administrator configured routers R1 and R2 as part of HSRP group 1. After the routers have been reloaded, a user on Host1 complained of…
Which two functions are performed by a WLC when using split media access control (MAC)? (Choose two.) packet acknowledgments and retransmissions frame translation to other protocols association and re-association of…
A technician is configuring a router for a small company with multiple WLANs and doesn't need the complexity of a dynamic routing protocol. What should be done or checked? Check…