H12-224 : HCNP-R&S Fast Track (Huawei Certified Network Professional – Routing & Switching Fast Track) : Part 03

H12-224 : HCNP-R&S Fast Track (Huawei Certified Network Professional – Routing & Switching Fast Track) : Part 03

1. When the GVRP registration mode is FORBIDDEN, no VLAN can be created or registered on the interface. In addition, which VLANs are deregistered on the interface?

   • All VLANs except VLAN 1 
   • All VLANs except VLAN 4095
   • All VLANs
   • All VLANs except the VLAN specified by the user

2. Which statement about the VLAN on a Layer 2 switch is true?

   • The CFI in the VLAN tag specifies whether the priority in the VLAN tag is valid. 
   • The VLAN tag is located in the Layer 2 header of a packet.
   • The CFI in the VLAN tag contains two bits.
   • A VLAN on the switch is a broadcast domain. The broadcast domains are separated.

3. Which statement about VLAN mapping is false?

   • VLAN mapping is also called VLAN translation.
   • VLAN mapping can implement translation between C-VLAN IDs and S-VLAN IDs.
   • VLAN mapping can be configured.
   • VLAN mapping means that a VLAN tag is added to packets. 

4. Which are the port roles defined in STP?

   • Root Port
   • Designated Port
   • Alternate Port
   • All of the above 

5. QinQ provides a simplified Layer 2 VPN tunnel.

   • True 
   • False

6. Which VLAN assignment methods are supported by the Huawei S9300? (Choose three.)

   • Assigning VLANs based on Layer 7 protocols
   • Assigning VLANs based on protocols
   • Assigning VLANs based on IP subnets
   • Assigning VLANs based on MAC addresses

7. Which statement about MUX VLAN is false?

   • Principal VLAN
   • Subordinate VLAN
   • Subordinate group VLAN
   • Guest VLAN 

8. Which is contained in the GVRP VLAN deregistration message?

   • Specified VLAN ID
   • Specified IP address
   • Specified MAC address 
   • Known port number

9. Which statements are true? (Choose three.)

   • The sub-VLANs are configured in the super VLAN view. 
   • VLANs 1 to 4094 can be configured as a super VLAN.
   • The aggregate-vlan command is used to configure the super VLAN.
   • A VLAN to be configured as a super VLAN cannot contain any interface.

10. On the STP network as shown in the figure, which device may be the blocked port belong to?

    

    • SWA
    • SWB
    • SWC 
    • None of the above

11. Which statements about the VLAN on S series switches are true? (Choose two.)

    • The VLAN IDs on the switch range from 1 to 4090.
    • The switch has a default VLAN.
    • The priority value in the VLAN tag can be changed on the switch.
    • A VLAN tag contains one byte.

12. As shown in the figure, port 1 of switch A is configured with the Fixed mode, and other ports are configured with the Normal mode. The trunk interfaces allow all VLANs. Which VLANs are registered on port 1 of switch C? (Choose three.)

    

    • VLAN 1 
    • VLAN 5 to VLAN 10
    • VLAN 15 to VLAN 20
    • VLAN 25 to VLAN 30

13. In STP configuration, which statement about BPDUs is true?

    • BPDUs cannot be sent from the designated port.
    • BPDUs can be sent only from the designated port. 
    • BPDUs can be sent from any port.
    • None of the above.

14. Which statements about the relationship between GVRP and GARP are true? (Choose two.)

    • GVRP, GARP, and GMRP are the standards of the same type.
    • GVRP and GARP are defined by IEEE 802.1p.
    • GVRP is based on GARP, and is an application of GARP.
    • GVRP is a new definition of GARP.

15. On an RSTP network, when an edge port is in protected state, what operation is performed after the edge port receives BPDUs?

    • The edge port forwards BPDUs.
    • The edge port discards BPDUs.
    • The edge port is shut down. 
    • The edge port obtains required information from BPDUs.

16. The dot1x authentication-method command is used to set the 802.1x authentication mode.

    Which is the most secure authentication mode?

    • PAP
    • EAP
    • CHAP 
    • EAP-TTLS

17. When the topology of a network running RSTP changes, what happens after the change?

    • Flooding on the entire network.
    • The aging time of MAC address entries is changed.
    • Some MAC address entries are deleted. 
    • All of the above

18. The port isolation function can isolate the ports on the same switch.

    • True 
    • False

19. Which statement about VLAN mapping is true?

    • The interface configured with VLAN mapping must be a hybrid interface.
    • The same VLANs on different interfaces cannot be mapped to different VLANs.
    • Different VLANs on the same interface can be mapped to the same VLAN. 
    • Any types of interfaces can be configured with VLAN mapping.

20. Which problems on a single spanning tree network can be solved by MSTP? (Choose three.)

    • Traffic forwarding paths in some VLANs are faulty.
    • Traffic cannot be load balanced.
    • The second best path problem may occur.
    • The network reliability cannot be improved.