Refer to the exhibit. A network administrator is configuring access control to switch SW1. If the administrator uses a console connection to connect to the switch, which password is needed to access user EXEC mode?

  • Post author:
  • Post category:Uncategorized
  • Post comments:0 Comments
  • Post last modified:November 2, 2020
  • Reading time:2 mins read

Last Updated on November 2, 2020 by Admin

Refer to the exhibit. A network administrator is configuring access control to switch SW1. If the administrator uses a console connection to connect to the switch, which password is needed to access user EXEC mode?

CCNA1 v7 – ITNv7 – Modules 1 – 3 Basic Network Connectivity and Communications Exam Answers 02
CCNA1 v7 – ITNv7 – Modules 1 – 3 Basic Network Connectivity and Communications Exam Answers 02
  • letmein
  • secretin
  • lineconin
  • linevtyin
    Answers Explanation & Hints:

    Telnet accesses a network device through the virtual interface configured with the line VTY command. The password configured under this is required to access the user EXEC mode. The password configured under the line console 0 command is required to gain entry through the console port, and the enable and enable secret passwords are used to allow entry into the privileged EXEC mode.

For more question and answers:

Click Here CCNA 1 ITN v7 – Modules 1 – 3: Basic Network Connectivity and Communications Exam Answers Full 100%

0 0 votes
Article Rating
Subscribe
Notify of
guest
0 Comments
Inline Feedbacks
View all comments