Refer to the exhibit. All workstations are configured correctly in VLAN 20. Workstations that are connected to switch SW1 are not able to send traffic to workstations on SW2. What could be done to remedy the problem?

Last Updated on October 29, 2020 by Admin

Refer to the exhibit. All workstations are configured correctly in VLAN 20. Workstations that are connected to switch SW1 are not able to send traffic to workstations on SW2. What could be done to remedy the problem?

CCNA2 v7 SRWE - Modules 1 - 4: Switching Concepts, VLANs, and InterVLAN Routing Exam Answers 07
CCNA2 v7 SRWE – Modules 1 – 4: Switching Concepts, VLANs, and InterVLAN Routing Exam Answers 07
  • Allow VLAN 20 on the trunk link.
  • Enable DTP on both ends of the trunk.
  • Configure all workstations on SW1 to be part of the default VLAN.
  • Configure all workstations on SW2 to be part of the native VLAN.
    Answers Explanation & Hints:

    Enabling DTP on both switches simply allows negotiation of trunking. The “Negotiation of Trunking” line in the graphic shows that DTP is already enabled. The graphic also shows how the native VLAN is 1, and the default VLAN for any Cisco switch is 1. The graphic shows the PCs are to be in VLAN 20.

For more question and answers:

Click Here CCNA 2 SRWE – Modules 1 – 4 – Switching Concepts, VLANs, and Inter-VLAN Routing Exam Answers Full 100%

0 0 votes
Article Rating
Subscribe
Notify of
guest
0 Comments
Inline Feedbacks
View all comments