Refer to the exhibit. An administrator is trying to troubleshoot connectivity between PC1 and PC2 and uses the tracert command from PC1 to do it. Based on the displayed output, where should the administrator begin troubleshooting?

Post author:InfraExam
Post published:January 16, 2019
Post category:Uncategorized
Post comments:0 Comments
Post last modified:January 16, 2019
Reading time:2 mins read

Last Updated on January 16, 2019 by InfraExam

Refer to the exhibit. An administrator is trying to troubleshoot connectivity between PC1 and PC2 and uses the tracert command from PC1 to do it. Based on the displayed output, where should the administrator begin troubleshooting?

ITN Chapter 11 Exam Answers 001

SW1

Explanation:

Tracert is used to trace the path a packet takes. The only successful response was from the first device along the path on the same LAN as the sending host. The first device is the default gateway on router R1. The administrator should therefore start troubleshooting at R1.

Refer to the exhibit. An administrator is trying to troubleshoot connectivity between PC1 and PC2 and uses the tracert command from PC1 to do it. Based on the displayed output, where should the administrator begin troubleshooting?

For All Questions: CCNA1 ITN Chapter 11 Exam Answers 2019

You Might Also Like

Which service would BEST accomplish this task?

There are many existing websites and mobile apps that use the web service that will not be updated to set the tip property for some time. How should you complete the trigger?

Match each functional component of AAA with its description. (Not all options are used.)