Refer to the exhibit. An administrator is trying to troubleshoot connectivity between PC1 and PC2 and uses the tracert command from PC1 to do it. Based on the displayed output, where should the administrator begin troubleshooting?

CCNA1 v7 - ITNv7 - Modules 11 - 13 IP Addressing Exam Answers 01
CCNA1 v7 – ITNv7 – Modules 11 – 13 IP Addressing Exam Answers 01
  • PC2
  • R1
  • SW2
  • R2
  • SW1
    Answers Explanation & Hints:

    Tracert is used to trace the path a packet takes. The only successful response was from the first device along the path on the same LAN as the sending host. The first device is the default gateway on router R1. The administrator should therefore start troubleshooting at R1.

For more question and answers:

Click Here CCNA 1 ITN v7 – Modules 11 – 13: IP Addressing Exam Answers Full 100%