Refer to the exhibit. If no router ID was manually configured, what would router Branch1 use as its OSPF router ID?

  • Post author:
  • Post category:Uncategorized
  • Post comments:0 Comments
  • Post last modified:November 7, 2020
  • Reading time:2 mins read

Last Updated on November 7, 2020 by Admin

Refer to the exhibit. If no router ID was manually configured, what would router Branch1 use as its OSPF router ID?

CCNA3 v7 – ENSA – Modules 1 – 2 OSPF Concepts and Configuration Exam Answers 03
CCNA3 v7 – ENSA – Modules 1 – 2 OSPF Concepts and Configuration Exam Answers 03
  • 10.0.0.1
  • 10.1.0.1
  • 192.168.1.100
  • 209.165.201.1
    Answers Explanation & Hints:

    In OSPFv2, a Cisco router uses a three-tier method to derive its router ID. The first choice is the manually configured router ID with the router-id command. If the router ID is not manually configured, the router will choose the highest IPv4 address of the configured loopback interfaces. Finally if no loopback interfaces are configured, the router chooses the highest active IPv4 address of its physical interfaces.

For more question and answers:

Click Here CCNA3 v7 – ENSA – Modules 1 – 2: OSPF Concepts and Configuration Exam Answers Full 100%

0 0 votes
Article Rating
Subscribe
Notify of
guest
0 Comments
Inline Feedbacks
View all comments