Refer to the exhibit. The administrator wants to enable port security on an interface on switch S1, but the command was rejected. Which conclusion can be drawn?​

Last Updated on November 10, 2022 by InfraExam

Refer to the exhibit. The administrator wants to enable port security on an interface on switch S1, but the command was rejected. Which conclusion can be drawn?​

• The interface must be initially configured with the switchport mode trunk command.​
• The interface needs to be configured initially with an IP address.
• The interface must be initially configured with the switchport mode access command.​
• The interface needs to be previously configured with the no shutdown command.​
  

  Answers Explanation & Hints: To enable port security, use the switchport port-security interface configuration command on an access port. By default, Layer 2 switch ports are set to dynamic auto (trunking on); therefore, the port must be initially configured as an access port before port security can be enabled.

For more question and answers:

Click Here CCNA 2 SRWE v7 – SRWE Practice Final Exam Answers Full 100%