Refer to the exhibit. What command would be used to configure a static route on R1 so that traffic from both LANs can reach the 2001:db8:1:4::/64 remote network?

  • Post author:
  • Post category:Uncategorized
  • Post comments:0 Comments
  • Post last modified:October 29, 2020
  • Reading time:2 mins read

Last Updated on October 29, 2020 by Admin

Refer to the exhibit. What command would be used to configure a static route on R1 so that traffic from both LANs can reach the 2001:db8:1:4::/64 remote network?

CCNA 2 SRWE v7 Modules 14 – 16 – Routing Concepts and Configuration Exam Answers 02
CCNA 2 SRWE v7 Modules 14 – 16 – Routing Concepts and Configuration Exam Answers 02
  • ipv6 route ::/0 serial0/0/0
  • ipv6 route 2001:db8:1:4::/64 2001:db8:1:3::1
  • ipv6 route 2001:db8:1:4::/64 2001:db8:1:3::2
  • ipv6 route 2001:db8:1::/65 2001:db8:1:3::1
    Answers Explanation & Hints:

    To configure an IPv6 static route, use the ipv6 route command followed by the destination network. Then add either the IP address of the adjacent router or the interface R1 will use to transmit a packet to the 2001:db8:1:4::/64 network.

For more question and answers:

Click Here CCNA 2 SRWE v7 – Modules 14 – 16 – Routing Concepts and Configuration Exam Answers Full 100%

0 0 votes
Article Rating
Subscribe
Notify of
guest
0 Comments
Inline Feedbacks
View all comments