Refer to the exhibit. The small company shown uses static routing. Users on the R2 LAN have reported a problem with connectivity. What is the issue? R2 needs a static…
Refer to the exhibit. Which set of commands will configure static routes that will allow the Park and the Alta routers to a) forward packets to each LAN and b)…
Refer to the exhibit. The network engineer for the company that is shown wants to use the primary ISP connection for all external connectivity. The backup ISP connection is used…
Refer to the exhibit. Which type of IPv6 static route is configured in the exhibit? directly attached static route recursive static route fully specified static route floating static route Answers…
Refer to the exhibit. Which default static route command would allow R1 to potentially reach all unknown networks on the Internet? R1(config)# ipv6 route 2001:db8:32::/64 G0/0 R1(config)# ipv6 route ::/0…
An administrator issues the ipv6 route 2001:db8:acad:1::/32 gigabitethernet0/0 2001:db8:acad:6::1 100 command on a router. What administrative distance is assigned to this route? 0 1 32 100 Answers Explanation & Hints:…
Consider the following command: ip route 192.168.10.0 255.255.255.0 10.10.10.2 5 How would an administrator test this configuration? Delete the default gateway route on the router. Ping any valid address on…
Consider the following command: ip route 192.168.10.0 255.255.255.0 10.10.10.2 5 What does the 5 at the end of the command signify? metric exit interface administrative distance maximum number of hops…
What network prefix and prefix-length combination is used to create a default static route that will match any IPv6 destination? ::/128 ::/0 ::1/64 FFFF::/128 Answers Explanation & Hints: A default…
What is a characteristic of a floating static route? It is used to provide load balancing between static routes. When it is configured, it creates a gateway of last resort.…
Refer to the graphic. Which command would be used on router A to configure a static route to direct traffic from LAN A that is destined for LAN C? A(config)#…
Refer to the exhibit. What command would be used to configure a static route on R1 so that traffic from both LANs can reach the 2001:db8:1:4::/64 remote network? ipv6 route…
Match the routing table entry to the corresponding function. (Not all options are used.) For more question and answers: Click Here CCNA 2 SRWE v7 – Modules 14 – 16…
Match the characteristic to the corresponding type of routing. (Not all options are used.) Answers Explanation & Hints: Both static and dynamic routing could be used when more than one…
Refer to the exhibit. What is the administrative distance value of the route for router R1 to reach the destination IPv6 address of 2001:DB8:CAFE:4::A? 1 4 110 120 Answers Explanation…
Which route would be used to forward a packet with a source IP address of 192.168.10.1 and a destination IP address of 10.1.1.1? C 192.168.10.0/30 is directly connected, GigabitEthernet0/1 S…
When would it be more beneficial to use a dynamic routing protocol instead of static routing? in an organization with a smaller network that is not expected to grow in…
What route would have the lowest administrative distance? a directly connected network a static route a route received through the EIGRP routing protocol a route received through the OSPF routing…
What is a characteristic of a static route that matches all packets? It backs up a route already discovered by a dynamic routing protocol. It uses a single network address…
Refer to the exhibit. PC A sends a request to Server B. What IPv4 address is used in the destination field in the packet as the packet leaves PC A?…