A network administrator is troubleshooting the dynamic NAT that is configured on router R2. Which command can the administrator use to see the total number of active NAT translations and the number of addresses that are allocated from the NAT pool?
- R2# show ip nat statistics
- R2# show ip nat translations
- R2# show running-config
- R2# clear ip nat translation
Answers Explanation & Hints: R2# show ip nat translations will display the current NAT translations. It will not provide the information on how many addresses are still left in the pool. R2# clear ip nat translation is used to clear the translation table of old entries so that when the R2# show ip nat translations command is issued, the current NAT translation entries are displayed. R2# show running-config will display the configuration parameters only. R2# show ip nat statistics will display information about the total number of active translations, NAT configuration parameters, the number of addresses in the pool, and the number that have been allocated.