H12-211 : HCIA Routing & Switching : Part 16

  1. On the network shown in the figure, if all links are Ethernet links and all routers run OSPF, how many DRs will be elected on the entire network?

    H12-211 HCIA Routing & Switching Part 16 Q01 059
    H12-211 HCIA Routing & Switching Part 16 Q01 059
    •  2
    • 4
    • 3
    • 1
  2. As shown in the preceding VTY configuration, the user privilege level is set to 3.

    H12-211 HCIA Routing & Switching Part 16 Q02 060
    H12-211 HCIA Routing & Switching Part 16 Q02 060
    • True
    • False
  3. What is the main function of DHCP Discover packets?

    • The client sends DHCP Discover packets for requesting to confirm the configuration or renew the lease time of the IP address.
    • The DHCP server sends DHCP Discover packets to respond DHCP Request packets.
    • The DHCP Discover packet carries various configuration information.
    • The client sends DHCP Discover packets to search for the DHCP server.
  4. As shown in the following figure, switch A and router A are connected through two links. The two links are aggregated in manual load balancing mode. The aggregation port number is 1. The aggregated link needs to carry VLAN tag 100. Switch A uses the trunk link.

    H12-211 HCIA Routing & Switching Part 16 Q04 061
    H12-211 HCIA Routing & Switching Part 16 Q04 061

    Which of the following configurations need to be performed on switch A?

    • H12-211 HCIA Routing & Switching Part 16 Q04 062
      H12-211 HCIA Routing & Switching Part 16 Q04 062
    • H12-211 HCIA Routing & Switching Part 16 Q04 063
      H12-211 HCIA Routing & Switching Part 16 Q04 063
    • H12-211 HCIA Routing & Switching Part 16 Q04 064
      H12-211 HCIA Routing & Switching Part 16 Q04 064
    • H12-211 HCIA Routing & Switching Part 16 Q04 065
      H12-211 HCIA Routing & Switching Part 16 Q04 065
  5. What is the total length of the VLAN frame defined by IEEE 802.1Q?

    • 4
    • 3
    • 2
    • 1
  6. Which of the following is the feature of port-based VLAN assignment?

    • VLAN IDs are allocated based on the protocol type and encapsulation format of data frames.
    • The VLAN does not need to be configured again when hosts move.
    • The VLAN tag is added to data frames based on the IP address carried in the frames.
    • The VLAN needs to be configured again when hosts move.
  7. If an Ethernet data frame carries Length/Type = 0x8100, which of the following cannot be the payload of the data frame?

    • RSTP data frame
    • OSPF packet
    • ARP response packet
    • STP data frame
  8. Which of the following statements about a port on a switch is false?

    H12-211 HCIA Routing & Switching Part 16 Q08 066
    H12-211 HCIA Routing & Switching Part 16 Q08 066
    • If the port receives data frames without VLAN tags, the switch needs to add VLAN tag 200.
    • If the VLAN tag carried in a data frame is 100, the switch removes the VLAN tag and sends the frame.
    • The link type of the port is trunk.
    • The port cannot send data frames carrying VLAN tag 200.
  9. According to the following topology and configuration, R1 and R2 are connected through low-speed serial cables and PPP is used to encapsulate data link layer packets. When the Holdtime values of R1 and R2 are different, PPP negotiation and communication fail.

    H12-211 HCIA Routing & Switching Part 16 Q09 067
    H12-211 HCIA Routing & Switching Part 16 Q09 067
    •  True
    • False
  10. Which of the following is not included in AAA?

    • Audit
    • Authentication
    • Authorization
    • Accounting
  11. Which of the following encapsulation modes are supported by IPsec VPN? (Choose two.)

    • Routing mode
    • Tunnel mode
    • Transport mode
    • Switching mode
  12. The IKE protocol is used to set up an SA for IPsec automatic negotiation. Identity authentication can be performed when the IP address of the initiator changes dynamically.

    • True
    • False
  13. Which of the following SNMP packets is sent by the agent on the managed device to the NMS?

    • Get-Request
    • Response
    • Get-Next-Request
    • Set-Request
  14. The RADIUS information of the router is configured as follows.

    H12-211 HCIA Routing & Switching Part 16 Q14 068
    H12-211 HCIA Routing & Switching Part 16 Q14 068

    Which of the following statements are correct? (Choose three.)

    •  The IP address of the authentication server is 200.0.12.1.
    • The IP address of the authorization server is 200.0.12.1.
    • The source IP address of the RADIUS packets sent by the router is 200.0.12.2.
    • The IP address of the accounting server is 200.0.12.1.
  15. Which of the following information must be configured for a DHCPv6 relay agent?

    • DHCPv6 address pool
    • DNS server address
    • IPv6 address of the DHCPv6 server
    • DHCPv6 DUID
  16. Which of the following statements are true according to the following command output?

    H12-211 HCIA Routing & Switching Part 16 Q16 069
    H12-211 HCIA Routing & Switching Part 16 Q16 069
    • The OSPFv3 area ID is 0.
    • The OSPFv3 process ID is 1.
    • The DR priority of the local router is 1.
    • The router ID of the neighbor is 10.0.1.1.
  17. According to the following configuration of Router C, how many global unicast address prefixes are advertised by Router C?

    H12-211 HCIA Routing & Switching Part 16 Q17 070
    •  1
    • 4
    • 2
    • 3
  18. If the MAC address of an interface is 0EE0-FFFE-0FEC, the corresponding EUI-64 address is ( ).

    • 0CE0-FFFF-FEFE-0FEC
    • 0EE0-FFFF-FEFE-0FEC
    • 0EE0-FFFE-FFFE-0FEC
    • 0CE0-FFFE-FFFE-0FEC
  19. Which of the following address types are of IPv6 addresses?

    • Unicast address
    • Anycast address
    • Multicast address
    • Broadcast address
  20. Segment routing-traffic engineering (SR-ТЕ) is a new ТЕ tunneling technology that uses SR as a control protocol. All nodes of an SR-TE tunnel, including the ingress and transit nodes, must be aware of the tunnel and complete label distribution and forwarding.

    • True
    • False
Subscribe
Notify of
guest
0 Comments
Newest
Oldest Most Voted
Inline Feedbacks
View all comments