H12-224 : HCNP-R&S Fast Track (Huawei Certified Network Professional – Routing & Switching Fast Track) : Part 16

  1. Based on classification rules, traffic classification can be divided into which of the following types? (Choose two.)

    • Simple traffic classification
    • Complex traffic classification
    • On-demand traffic classification
    • Service traffic classification
  2. A company has four departments. Department A has 80 PCs, Departments B and C both have 20 PCs, and Department D has 30 PCs. Assuming the IP address 192.168.1.0/x is used, which of the following statements are true if the VLSM technology is used to divide subnets? (Choose two.)

    • Plan subnet 192.168.1.0/25 for Department A. The range of host addresses is 1 to 126. 
    • Plan subnet 192.168.1.128/27 for Department B. The range of host addresses is 129 to 159.
    • Plan subnet 192.168.1.160/27 for Department C. The range of host addresses is 161 to 190. 
    • Plan subnet 192.168.1.192/27 for Department D. The range of host addresses is 192 to 222.
  3. Which statement about OSPF is false?

    • The router with a higher Router Priority also has a higher DR election priority.
    • When two routers have the same Router Priorities, the router with a larger Router ID has a higher DR election priority.
    • If a DR fails, the BDR automatically takes over as the DR and a new BDR is elected.
    • If a BDR fails, the DR will not take over as the BDR and awaits the fault recovery of the BDR. No new BDR will be elected. 
  4. The network 154.27.0.0 without any subnet can support() hosts?

    • 254
    • 1024
    • 65,534 
    • 16,777,206
  5. Which of the following statements about a neighbor state machine is true?

    • The Attempt state appears only on an NBMA network or a broadcast network.
    • The Attempt state appears only on an NBMA network or a P2MP network.
    • LSR packets can be sent in the Exchange state. 
    • The Full state indicates that LSDB synchronization is complete. No LSDB information will be exchanged.
  6. Which of the following IP addresses are network addresses? (Choose two.)

    • 64.104.3.7/28
    • 192.168.12.64/26 
    • 192.135.12.191/26
    • 198.18.12.16/28 
  7. Assume that the VRID of a VRRP virtual router is 100 and the virtual IP address of the virtual router is 192.168.1.1, which of the following addresses is the virtual MAC address of the virtual router?

    • 00-00-5E-00-01-64 
    • 00-00-5E-00-01-01
    • 01-00-5E-00-01-64
    • 01-00-5E-00-01-01
  8. What are the OSPF message types? (Choose four.)

    • Hello
    • Database Description
    • Link State Request
    • Link State Update
    • Link State Advertisement
  9. Which of the following statements are correct regarding Network LSA in OSPF network? (Choose two.)

    • Network LSA is generated by ABR.
    • Only the router which connects NBMA or Broadcast Network may generate Network LSA.
    • DR uses Network LSA to describe routers that have established adjacency relation with it in the network.
    • Network LSA is flooded in the whole AS.
  10. A broadcast and an NBMA network, each having two or more routers, must both have a DR and a BDR.

    • True
    • False 
  11. ABRs advertise link status information about connected non-backbone areas to the backbone area. The backbone area then advertises the routing information to other non-backbone areas. Link status information about the backbone area cannot be advertised to non-backbone areas.

    • True
    • False 
  12. OSPF directly runs over the IP protocol. Its IP protocol number is 89.

    • True 
    • False
  13. Which of the following statements about link aggregation are true? (Choose three.)

    • Link aggregation binds a group of physical interfaces together as a logical interface to increase the bandwidth and reliability. 
    • Link aggregation complies with IEEE 802.3az.
    • The logical link formed by bundling multiple physical links together is called a link aggregation group (LAG) or a trunk.
    • Active and inactive interfaces exist in link aggregation. Active interfaces forward data, whereas inactive interfaces do not.
  14. When links are switched in a Smart Link group, which of the following mechanisms can be used to refresh MAC and ARP entries? (Choose three.)

    • MAC and ARP entries are refreshed automatically with respect to traffic.
    • The Smart Link group uses a new link to send Flush packets.
    • MAC entries are refreshed after the aging time expires.
    • ARP entries are refreshed after the aging time expires
  15. Which of the following statements about the BFD asynchronous mode are true? (Choose two.)

    • The local system regularly sends BFD control packets, and the remote system detects the BFD control packets sent from the local system. 
    • The local system detects the BFD control packets sent by itself.
    • If one system does not receive any BFD packets from its peer within a detection period, it advertises a session Down event. 
    • Each system confirms its connections with other systems in a particular method. After a BFD session is set up, BFD control packets are no longer sent.
  16. Routes 172.1.12.0/24, 172.1.13.0/24, 172.1.14.0/24, and 172.1.15.0/24 can be summarized into route 172.1.8.0/21.

    • True 
    • False
  17. Which of the following statements are true? (Choose three.)

    • The neighbor state machine can transition from the Down state to the Exchage state.
    • The neighbor state machine can transition from the Down state to the Init state.
    • The neighbor state machine can transition from the Init state to the Exstart state.
    • The neighbor state machine can transition from the Init state to the 2-Way state.
  18. A router receives a data packet, with the destination address being 195.26.17.4. Which subnet is this address in?

    • 195.26.0.0/21
    • 195.26.16.0/20 
    • 195.26.8.0/22
    • 195.26.20.0/22
  19. Which of the following statements about the reliability requirement level are true? (Choose three.)

    • Faults seldom occur in the system software or hardware. 
    • System functions are affected by faults.
    • System functions are affected by faults but can rapidly recover.
    • System functions can be ensured by using redundancy design, switchover policy, and high success rate in switchover.
  20. The value of ospfdr-priority ranges from 0 to 255 and the default value is 64.

    • True
    • False 
Subscribe
Notify of
guest
0 Comments
Newest
Oldest Most Voted
Inline Feedbacks
View all comments